Skip to main content
NetApp Knowledge Base

Is it possible to run SnapMirror and "volume move" task in parallel?

  1. Last updated
  2. Save as PDF
Views:
211
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
DP
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • volume move command

Answer

Note: SnapMirror relationships must be initialized before it can move one of the volumes.
Note: When the volume move cutover occurs (the moment ONTAP redirects I/O to the new volume), the active SnapMirror transfer is then momentarily interrupted and automatically continues from the source volume's new location.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.