Skip to main content
NetApp Knowledge Base

Are qtree replicated with SnapMirror

  1. Last updated
  2. Save as PDF
Views:
398
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • Qtree 

Answer

  • Yes,ONTAP allows creation of qtrees, and qtrees can exist in volumes that are replicated with SnapMirror.
  • However, SnapMirror does not allow replication of individual qtrees or qtree-level replication because SnapMirror replications operates only at the volume level.

While individual qtree level replication is not supported, qtrees inside a data volume will be replicated as a part of volume replication.

Additional Information

TR-4015: SnapMirror Configuration and Best Practices Guide for ONTAP 9.11.1

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.