Skip to main content
NetApp Knowledge Base

Volume efficiency changelog overflow value does not reset

  1. Last updated
  2. Save as PDF
Views:
423
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

Applies to

  • ONTAP 9
  • Storage efficiency

Issue

  • After a changelog full (sis.changelog.full:warning) event, ONTAP shows changelog overflow for the volume:
::> set diag
::*> volume efficiency show -fields changelog-usage,changelog-size,changelog-overflow
vserver volume changelog-usage changelog-size changelog-overflow
------- ------ --------------- -------------- ------------------
svm1    vol1   82%             33.85GB        836.6GB
  • A manual volume efficiency job was successfully run, but the changelog-overflow value did not reset:
::*> volume efficiency show -fields changelog-usage,changelog-size-changelog-overflow
vserver volume changelog-usage changelog-size changelog-overflow
------- ------ --------------- -------------- ------------------
svm1    vol1   0%              0B             836.6GB

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.