Move volume shows the error: Preparing source volume for cutover : Deduplication is not ready for volmove cutover
Applies to
- ONTAP 9
- OnCommand System Manager
- Running "
volume move
"
Issue
- When trying to move a volume on System Manager, the following error occurs.
Example:
The volume move operation of volume 'vol1' in Vserver 'vserver1' to destination aggregate 'aggr1' did not enter the cutover phase. The system provided the additional explanation: 'Preparing source volume for cutover: Deduplication is not ready for vol move cutover'. After a short delay, the volume move operation will reattempt cutover entry. The job ID for the volume move job is '1234'.
- "
volume move show
" shows a result like the following.
Example:
cluster::> volume move show
Vserver Volume State Move Phase Percent-Complete Time-To-Complete
--------- ---------- -------- --------------------- ---------------- ------------------------
vserver1 vol1 healthy cutover_soft_deferred 98% Sat May 23 20:02:53 2020
- The following error message is seen in the result of "
volume move show -details
".
Example:
Detailed Status: Waiting to Cutover. (Preparing source volume for cutover: Deduplication is not ready for volmove cutover Sent)::Reason: 3.11TB Volume move job monitoring transfer of data.
sis
log file (SIS-LOG.GZ
in ASUP) shows an error like the following.
Example:
Sat May 23 22:00:00 CST 2020 [Vserver UUID: 80dfdc3e-d89e-11e7-9c8d-00a098b8d178] /vol/vol1 [sid: 0] Error (A volume move operation is in progress. Use the "volume move show" command to view the status of the move. Retry this command when the move is complete. )
- After a few minutes,
mgwd.log
indicates that the "volume move
" succeeded.
Example:
Sat May 23 22:16:16 CST [node: mgwd: mgmt.vopl.move.done:notice]: The volume move job with ID '1234' on volume 'vol1' on Vserver 'vserver1' to destination aggregate 'aggr1' succeeded.