Skip to main content
NetApp Knowledge Base

Unable to move a Brocade Switch port

  1. Last updated
  2. Save as PDF
Views:
987
Visibility:
Public
Votes:
6
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • FCP
  • Brocade

Issue

Problem while moving a switch port. The following error is generated:

XXXXXXXXXXXX:FID128:admin> lscfg --config xxx -slot x -port 
This operation requires that the affected ports be disabled.
Would you like to continue [y/n]?: y
Making this configuration change.  Please wait...
lscfg:  The system is not ready for Logical Switch management operations.  Please try again shortly.
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.