Skip to main content
NetApp Knowledge Base

How do Brocade X6 switches react to firmwaredownload command?

  1. Last updated
  2. Save as PDF
Views:
234
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

Brocade X6 Director

Answer

  • For firmwaredownload to be non-disruptive on a Brocade X6 switch the command hashow needs to show all blades HA state is synchronized.
switch:admin> hashow
Local CP (Slot 5, CP0): Active, Warm Recovered
Remote CP (Slot 6, CP1): Standby, Healthy
HA enabled, Heartbeat Up, HA State synchronized
 
  • Standby CP is expected to have the upgrade performed first.
  • This allows the Standby CP to take over the Active CP once it is complete.
  • If the HA State is unsynchronized you can attempt to resynchronize by using command hasyncstart

Additional Information

NA
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.