Skip to main content
NetApp Knowledge Base

FOS firmware upgrade hung on STANDBY CP

  1. Last updated
  2. Save as PDF
Views:
303
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade X6-4
  • FOS 8.1x
  • FOS 8.2x

Issue

  1. STANDBY CP1 is in boot loop
  2. ACTIVE CP0 has new firmware applied and in normal state
  3. firmwareshow:

    Slot Name Appl Primary/Secondary Versions Status
    --------------------------------------------------------------------------
    1 CP0 FOS v8.2.2d4 ACTIVE *
    v8.2.2d4
    2 CP1 FOS v8.1.2d STANDBY
    Unknown
    * Local CP

    WARNING: Firmwaredownload is in progress.

  4. hadisable / haenable cannot not be applied / is not successful.
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.