Skip to main content
NetApp Knowledge Base

Double Density SFP does not fit into the switch port

  1. Last updated
  2. Save as PDF
Views:
25
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

This knowledge base was generated through a script and may contain formatting issues. For the accurate content, please refer to the WIP editor. WIP editor.

Applies to

  • Brocade switches
  • Double Density SFPs

Issue

  • Double density SFP does not fit into the switch port as it gets stuck halfway.
  • For fault isolation, below steps can be followed: 
    • Transceivers are keyed so that they can be inserted only with the correct orientation.
    • If a transceiver does not slide in easily, ensure that it is correctly oriented.
    • Push the correctly oriented transceiver into the port until it is firmly seated and the latching mechanism clicks. 
    • Clean and reseat the SFP
    • Check the ports for any obstructions
    • Swap SFP with another double density SFP and see if it works.
    • If it works then proceed with solution.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.