Skip to main content
NetApp Knowledge Base

Brocade Switch fails to boot due to Firmware integrity check failed

  1. Last updated
  2. Save as PDF
Views:
4
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade Switch
  • Fabric OS (FOS)

Issue

  • Switch continuously reboots after cold boot
  • Console logs show Firmware integrity check failed:

m41t11: I2C Real-Time-Clock detected on iic0 addr 0x68
sd 0:0:0:0: [sda] No Caching mode page found
sd 0:0:0:0: [sda] Assuming drive cache: write through
init scripts validation failed
INIT: version 2.88 booting
e2fsck 1.42.9 (28-Dec-2013)
/dev/sda2: clean, 9689/59008 files, 167976/236032 blocks
Filesystem check /dev/sda2 done
e2fsck 1.42.9 (28-Dec-2013)
/dev/sda1: clean, 9445/59136 files, 90274/236328 blocks
Filesystem check /dev/sda1 done
Validating integrity of firmware on root filesystem
Please wait...
..5.....   /fabos/cliexec/traceCreateDb
Firmware integrity check failed.
System is rebooting...
reboot: Restarting system

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.