Skip to main content
NetApp Knowledge Base

Brocade G610 switch in dead state

  1. Last updated
  2. Save as PDF
Views:
320
Visibility:
Public
Votes:
1
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade G610

Issue

  • Brocade G610 switch in dead state
  • Switch is not getting any power and pings to the switch isn't working
  • Unable to login to the CLI of the switch
  • Below troubleshooting steps can be tried:
    • Perform switch power cycle and try to boot up the switch
    • Check if power cable is connected properly and try to swap with good known power cable
    • Swap the port that power cable is plugged into and see if switch comes up
    • Try connecting  the power cord to a different power source/PDU

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.