Skip to main content
NetApp Knowledge Base

Brocade switch port(s) state showing as "Hard_Flt"

Views:
2,850
Visibility:
Public
Votes:
3
Category:
fabric-interconnect-and-management-switches
Specialty:
metrocluster
Last Updated:

Applies to

Brocade Switch

Issue

  • One or more ports on Brocade switch are showing state as "Hard_Flt"

Index Port Address  Media Speed   State       Proto
==================================================
  20  20   051400   id    8G       Hard_Flt    FC  
  21  21   051500   id    8G       Hard_Flt    FC  

portshow 20
portDisableReason: None
portCFlags: 0x1
portFlags: 0x4441     PRESENT U_PORT LED FAULT
LocalSwcFlags: 0x0
portType:  27.0
POD Port: Port is licensed
portState: 2    Offline  
Protocol: FC
portPhys:  15    Hard_Flt     portScn:   2    Offline   
port generation number:    70
state transition count:    42
  • In errdump, you will see the following events being reported:

2020/10/15-11:50:24, [C4-1002], 9154, FFDC | CHASSIS, ERROR, BrocadeG610, Port 20 chip failed due to an internal error.

2020/10/15-11:50:51, [C4-1002], 9155, FFDC | CHASSIS, ERROR, BrocadeG610, Port 21 chip failed due to an internal error.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.