Skip to main content
NetApp Knowledge Base

E-Series E2700 booting up only after pressing C on console if the system was powered off previously

  1. Last updated
  2. Save as PDF
Views:
273
Visibility:
Public
Votes:
0
Category:
e-series-santricity-os-controller-software
Specialty:
esg
Last Updated:

Applies to

  • E-Series E2700
  • SANtricity 8.40.60.04

Issue

  • E-Series E2700 is not booting automatically after it has been powered off,it is necessary to press C on the console :

7205 QLOGIC EP8324 ISCSI 2

01 Register Read Test Passed

02 Register Address Lines Test Passed

03 Register Data Lines Test Passed

3900 Real-Time Clock

01 RT Clock Tick ** Failed **



*** Error (0005): Real time clock/NVSRAM battery low



STATUS: Real time clock/NVSRAM battery low



*** Current Loop Count: 1 Date: 03/10/2023 Time: 07:27:30



*** Master Error Code: 2701-3900-01-0005





D)isplay R)etry C)ontinue M)onitor S)hell A)bort ?

  • System is rebooting automatically if the reboot is done from Santricity

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.