Skip to main content
NetApp Knowledge Base

Can I change the workload of a volume in Santricity System Manager?

  1. Last updated
  2. Save as PDF
Views:
114
Visibility:
Public
Votes:
3
Category:
e-series-santricity-storage-manager
Specialty:
esg
Last Updated:

Applies to

  • NetApp E-Series
  • Santricity System Manager

Answer

No, it is not possible to modify the workload of a volume through the GUI. However, the following workaround should also be effective.

  1. Delete the workload assigned to the volume, which unassigns that workload from all linked volumes.
  2. Assign the volume with the new / desired workload.
  3. Recreate and assign the old workload to any volumes that should have it.

Be Aware !! During the procedure above affected volumes would not have any assigned workload but should not affect the host access to the volumes.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.