Skip to main content
NetApp Knowledge Base

Drive displays unassigned after replacement on StorageGRID Appliance

  1. Last updated
  2. Save as PDF
Views:
858
Visibility:
Public
Votes:
0
Category:
e-series-santricity-management-software
Specialty:
esg
Last Updated:

Applies to

  • NetApp StorageGRID Appliances
  • SANtricity 11.60.2R1

Issue

After replacing a failed drive, the replacement drive shows as unassigned and SANtricity does not trigger reconstruction.

The recovery GURU will display:
Failure Entry 1: DISK_POOL_RECONSTRUCTION_DRIVE_COUNT_BELOW_THRESHOLD-Recovery Failure Type Code: 424

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.