Skip to main content
NetApp Knowledge Base

Ethernet I/O Module Port Offline After ONTAP Upgrade

Views:
3
Visibility:
Public
Votes:
0
Category:
asa-r2
Specialty:
hw
Last Updated:

Applies to

  • NetApp ASA-A20 systems
  • ONTAP version 9.18.1P5

Issue

After upgrading ONTAP to version 9.18.1P5, the e2d port on the 4-port Ethernet card in slot 2 went offline.The following troubleshooting steps were attempted without resolution: replacing the SFP module, changing the fiber cable, using a different switch port, and adjusting configuration. The issue persisted until the iSCSI service was moved to the e2b port, at which point connectivity was restored.

                                                  Speed(Mbps) Health
Port      IPspace      Broadcast Domain Link MTU  Admin/Oper  Status
--------- ------------ ---------------- ---- ---- ----------- --------
e0M       Default      Default          up   1500  auto/1000  healthy
e2a       Cluster      Cluster          up   9000  auto/25000 healthy
e2b       Default      Default-1        up   9000  auto/10000 healthy
e2b-2307  Default      iSCSI_Fabric_1   up   9000     -/-     healthy
e2b-2350  Default      Replication      up   9000     -/-     healthy
e2c       Default      -                down 1500  auto/-     -
e2d       Default      Default-1        down 9000  auto/-     -
e2d-2307  Default      iSCSI_Fabric_1   down 9000     -/-     -
e2d-2350  Default      Replication      down 9000     -/-     - 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.