Skip to main content
NetApp Knowledge Base

Why is an ONTAP cluster missing from the Unified Manager web interface?

Views:
154
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:

Applies to

  • Active IQ Unified Manager
  • OnCommand Unified Manager

Answer

  • Before considering the cluster as missing from the interface, check the cluster setup page to confirm it was added as a data source. The cluster must have been successfully added previously and exist as a data source in order for the cluster objects to show up in the web UI.
  • If the cluster in question is displayed on the cluster setup page but there are cluster objects missing from the UI, check the "Operation State" field to make sure health polling is successful. The cluster data source must have collected successfully for cluster objects to be updated, or for new objects to be discovered.

If the cluster data source is showing successful health inventory polls but objects are still missing from the UI, contact NetApp Support for further assistance.

Additional Information

additionalInformation_text

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device