Skip to main content
NetApp Knowledge Base

Why has ActiveIQ Unified Manager stopped receiving configured EMS events from a cluster after ONTAP was upgraded to a newer release?

  1. Last updated
  2. Save as PDF
Views:
296
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:

Applies to

  • OnCommand Unified Manager (OCUM) 7.x - 9.5.x
  • Active IQ Unified Manager (AIQUM) 9.6.x+

Answer

  • Verify the event has not been marked as deprecated.  If the event has been marked deprecated, it must be removed from Unified Manager EMS Subscriptions and a new event configured.
  • Execute appropriate clustershell commands on each cluster that has stopped sending events to verify that Unified Manager is listed as a syslog destination and that the event of interest is configured to be routed to the Unified Manager syslog destination.

Additional Information

Refer to the following articles for more setup information about EMS-based event subscriptions in Active IQ Unified Manager:

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.