Skip to main content
NetApp Knowledge Base

Power Supply failure alert incroctly displayed on StorageGRID

Views:
33
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

  • StorageGRID 11.9.0.6
  • SANtricity 11.90.R2
  • SG6160 with DE460C expansion shelves

Issue

  • During a power supply failure test on StorageGRID, the following behavior is observed:
    • When turning off the power supply for PSU-A , two messages indicating instability in system A and B's power supply are output from StorageGRID Grid Manager.
    • When turning off the power supply for PSU-B , no message is output.
  • Alert shows:
Appliance storage controller power supply A failure
Power supply A in a StorageGRID appliance has deviated from the recommended operating voltage.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.