Skip to main content
NetApp Knowledge Base

CSNAPC-11168: Snapcenter should retry 'Add-NcLunMap' when clone fails due to vserver reconfig locking

  1. Last updated
  2. Save as PDF
Views:
55
Visibility:
Public
Votes:
0
Category:
snapcenter
Specialty:
snapx
Last Updated:

Issue

When SnapCenter tries to map the LUN from a just created clone the lun-map request can:
a) timeout after 60 seconds (default API storage timeout)
b) fail after 118 seconds with "This Vserver is temporarily locked from changes while recording the configuration baseline. Try again in a few minutes or manually stop configuration replication by running "vserver config-replication pause" and retry the command."

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.