Skip to main content
NetApp Knowledge Base

Search

  • Filter results by:
    • View attachments
    Searching in
    About 3 results
    • How to perform Copy-Then-Replace operation on E-Series drives
      https://kb.netapp.com/on-prem/E-Series/Management-Apps-KBs/How_to_perform_Copy-Then-Replace_operation_on_E-Series_drives
      Applies to NetApp E-Series Description This article describes the various methods for on-demand drive evacuation of E-Series drives using the Copy-then-replace operation.
    • Replaced drive does not start reconstruction or copyback, displays unassigned
      https://kb.netapp.com/on-prem/E-Series/Hardware-KBs/Replaced_drive_does_not_start_reconstruction_or_copyback_displays_unassigned
      Applies to NetApp E-Series Issue The replaced drive does not start reconstruction or copyback and displays unassigned.
    • E-Series Drive unresponsive after replacement
      https://kb.netapp.com/on-prem/E-Series/Hardware-KBs/E-Series_Drive_unresponsive_after_replacement
      NetApp E-Series All firmware releases The drive is showing unresponsive after the replacement. 99, 4, 6 Optimal 10.692 TB Hard Disk Drive SAS 12 Gbps HUH721212AL5204 NE00 DA 99, 4, 7 Unresponsive 99, ...NetApp E-Series All firmware releases The drive is showing unresponsive after the replacement. 99, 4, 6 Optimal 10.692 TB Hard Disk Drive SAS 12 Gbps HUH721212AL5204 NE00 DA 99, 4, 7 Unresponsive 99, 4, 8 Optimal 10.692 TB Hard Disk Drive SAS 12 Gbps HUH721212AL5204 NE00 DA Recovery GURU message shows: Failure Entry 4: FAILED_DRIVE-Recovery Failure Type Code: 23 Storage array: ArrayName Component reporting problem: Drive in bay 0 Status: Unresponsive Location: Controller/Drive shelf 0, Drawer 0