Skip to main content
NetApp Knowledge Base

Workflow Automation fails to add RDM disk after updating VMware certificates

Views:
171
Visibility:
Public
Votes:
0
Category:
oncommand-workflow-automation-wfa
Specialty:
legacy
Last Updated:

Applies to

Workflow Automation (WFA) 5.1

Issue

Updating certificates in VMWare leads to fail to add Raw Device Mapping (RDM) disks in VMWare related workflows in WFA.
 
The error seen in WFA is:
New-HardDisk
The operation for the entity "name" failed with the following message: "A general system error occurred: PBM error occurred during PreReconfigureCallback: Fault cause: vmodl.fault.SystemError
 
WFA_error
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.