Skip to main content
NetApp Knowledge Base

Unable to gather data from 7MTT Assessment report

  1. Last updated
  2. Save as PDF
Views:
94
Visibility:
Public
Votes:
0
Category:
7-mode-transition-tool
Specialty:
7dot
Last Updated:

Applies to

7-Mode Transition Tool (7MTT)

Issue

After adding the systems to 7MTT, transition assessment report generation fails with the following error:

Authentication or network error (Errno: 10060, A connection attempt failed because the connected party did not properly respond after a period of time, or established connection failed because connected host has failed to respond). Please check host name or IP address and credentials used. Check if HTTPD is enabled using 'options httpd.admin.enable on'. Check if SSH2 is enabled using 'secureadmin' command. Check if SSL is enabled using 'options ssl'. Check the credentials and user privileges.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.