Skip to main content
NetApp Knowledge Base

Invalid qtree name error in Quota initialization

  1. Last updated
  2. Save as PDF
Views:
513
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
7dot
Last Updated:

Applies to

Data ONTAP

Issue

"Invalid qtree name /vol/volume_name/qtree_name"  error during quota initialization for existing rules in quota show.

After reinitialization of quotas if you run volume quota show command it gives an error as below for exisitng quota rule. We will not able to see the same quota rule from system manager.
 

cluster::> quota show -vserver volume_name
 Scan
Vserver Volume State Status
--------- ------------ --------------- ------
vs1   volume_name  on - Last Error: Invalid qtree name /vol/volume_name/qtree_name (type:tree target:/vol/volume_name/qtree_name qtree:"").

2 entries were displayed.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.