Skip to main content
NetApp Knowledge Base

Disk showing 'init failed' after replacement on ONTAP 7-mode system

  1. Last updated
    Aug 17, 2023
  2. Save as PDF
Views:
252
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
7dot
Last Updated:
8/17/2023, 6:56:39 PM

Applies to

  • ONTAP 8.2.5 7-mode
  • X483

Issue

  • Failed disk drive replaced with alternate part model showing 'init failed' after replacement
  • EMS logs indicate drive is not supported on current version with alert similar to the following
[ntap01: pmcsas_intrd_0: disk.min.OS.error:error]: Disk 0a.00.11L1 is not supported because it requires a minimum kernel version of 9.0.0. Current version is 8.2.5P5 7-Mode.
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.