Skip to main content
NetApp Knowledge Base

ACP not-responding

Last Updated:

Applies to

Data ONTAP 8 7-Mode



ACP Connectivity Status reports Partial Connectivity  and the module reports a status of 'not-responding':

filer> storage show acp
Alternate Control Path:  Enabled
Ethernet Interface:      e0P
ACP Status:              Active
ACP IP Address:
ACP Domain:    
ACP Netmask:   
ACP Connectivity Status:
Partial Connectivity 

Shelf Module      Reset Cnt    IP Address      FW Version   Module Type  Status
----------------- ------------ --------------- ------------ ------------ -------

0a.00.A           000   01.20        IOM3         not-responding (last contact at: "Mon Apr 23 22:47:55 EST 2012")
0a.00.B           000    01.20        IOM3         not-responding (last contact at: "Mon Apr 23 22:45:14 EST 2012")


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.


  • Was this article helpful?