Skip to main content
NetApp Knowledge Base

How to use iPerf to measure end-to-end network throughput in AltaVault

  1. Last updated
  2. Save as PDF
Views:
1,724
Visibility:
Public
Votes:
0
Category:
altavault
Specialty:
legacy
Last Updated:

Applies to

  • AltaVault (AVA)
  • iPerf

Description

  • iPerf is an open-source network bandwidth measurement tool that can be useful in troubleshooting a front-end performance issue
  • It is intended to be used to measure end-to-end network throughput
  • An interface cannot be specified and the path dictated by the main routing table will be used
    • This is the routing table used by the primary, aux VIF interfaces 
    • If the AVA is configured to use an interface other than primary, a static route should be used to route the iPerf connection out of the desired interface

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.