Skip to main content
NetApp Knowledge Base

No LACP feature on Cisco 3132QV switch after NX-OS 9.3(9) upgrade

  1. Last updated
  2. Save as PDF
Views:
116
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco 3132Q-V Cluster Network Switch
  • NX-OS 9.3(9)
  • ONTAP 9
  • Metrocluster-IP

Issue

  • During upgrade of the Cisco NX-OS on a Cisco 3132Q-V cluster switch the LACP feature disappeared.  After the switch was reloaded the port-channels were down and showed Protocol NONE.
  • Attempting to enable 'feature lacp' on the switch failed and no lacp commands were available in the command list.
  • Check of the .bin file on the bootflash showed that the os.bin image was not the correct size compared to the source file on the ftp server.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.