Skip to main content
NetApp Knowledge Base

Can a Brocade SAN switch interoperate with Cisco SAN switch ?

  1. Last updated
  2. Save as PDF
Views:
1,162
Visibility:
Public
Votes:
1
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade SAN switch FOS v7.0.0 and later

Answer

No, prior to FOS v7.0.0, Brocade FOS provides interop Mode 1 to interoperates with Brocade and McData and Cisco switches

For example:
Brocade:admin> interopmode 1 <==== Set interop mode on
 
The command was implemented to support the McDATA switches after Brocade bought McData, and the command had been deprecated starting from FOS 7.0.0 when the McDATA devices went into End of Support.
 
After FOS v7.0.0, the Brocade SAN switches are not interoperable with Cisco SAN switches. the Cisco devices can only join the Brocade Fabric as NPIV devices.

Additional Information

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.