Skip to main content
NetApp Knowledge Base

How to troubleshoot Host Redundancy Lost Alerts

  1. Last updated
  2. Save as PDF
Views:
4,874
Visibility:
Public
Votes:
5
Category:
e-series-systems
Specialty:
esg
Last Updated:

​ ​

Applies to

NetApp E-Series

Description

  • Recovery GURU and Major Event Log (MEL) reports the following errors:
    • Loss of host-side connection redundancy detected
    • Volume not on preferred path due to AVT/RDAC failover
  • Host Redundancy Lost indicates that a host only has a path to one controller. This can occur for two primary reasons:
    1. The host has only been set up for the connections to one controller.
    2. The host loses a path in the fabric that causes the path to one controller to fail. This can be the result of either of the following.
      • Change in the environment such as a cabling change.
      • SAN errors cause the path to failure.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.