Skip to main content
NetApp Knowledge Base

Are any additional steps needed after an encrypted volume is created to ensure that the data is encrypted?

  1. Last updated
  2. Save as PDF
Views:
137
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Answer

  • No. If the volume was created with encryption enabled, ONTAP makes sure that the data within that volume is encrypted
  • This can be verified with the volume show -is-encrypted true command:

cluster2::> volume show -is-encrypted true

Vserver  Volume  Aggregate  State  Type  Size  Available  Used
-------  ------  ---------  -----  ----  -----  --------- ----
vs1      vol1    aggr2     online    RW  200GB    160.0GB  20%

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.