Skip to main content
NetApp Knowledge Base

Does ATTO bridge request to restart/reboot after change management IP address ?

  1. Last updated
  2. Save as PDF
Views:
698
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ATTO FibreBridge

Answer

Yes, after configure or modify ATTO management IP address, you must run the commands"SaveConfiguration" and you are prompted to restart the bridge to put the new configuration into effect.

Note:To set the IP address without the QuickNAV utility, you need to have a serial connection to the FibreBridge.

Example:
If using the CLI, you must run the following commands:

set ipaddress mp1 ip-address
set ipsubnetmask mp1 subnet-mask
set ipgateway mp1 x.x.x.x
set ipdhcp mp1 disabled
set ethernetspeed mp1 1000
SaveConfiguration

You are prompted to restart the bridge.

Additional Information

 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.