Skip to main content
NetApp Knowledge Base

CSRF token failure when running REST call against OnCommand WorkFlow Automation workflow

  1. Last updated
  2. Save as PDF
Views:
355
Visibility:
Public
Votes:
0
Category:
oncommand-workflow-automation-wfa
Specialty:
legacy
Last Updated:

Applies to

  • OnCommand Workflow Automation (WFA) 5.1
  • Platform independent

Issue

When executing a workflow outside of WFA 5.1 through a REST client or orchestration software like Postman or vRealize Orchestrator, the workflow fails with the below error message:

No CSRF token found in session

If executing the workflow from WFA's SwaggerUI, the following message may be observed as well:

CSRF token validation failed

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.