Skip to main content
NetApp Knowledge Base

SAN initiator group showing empty in System manager GUI after upgrade

  1. Last updated
  2. Save as PDF
Views:
867
Visibility:
Public
Votes:
0
Category:
ontap-system-manager
Specialty:
om
Last Updated:

Applies to

  • ONTAP System Manager
  • ONTAP 9.8x , 9.11.x

Issue

  • Post ONTAP Upgrade from 9.8 to 9.11, SAN initiator groups show empty (no initiators added) in GUI but are present in the CLI.  Additionally, hosts are connected and have no issues. SAN initiator group showing empty in System manager GUI after upgrade
  • REST APIs fail to show initiators when viewing or retrieving igroups.
  • Adding the missing initiators to the igroups fails indicating that they already contain the initiators
  • Deleting the igroups fail with error : Initiator group does not contain the initiator as shown below

::*> lun igroup remove -vserver XX -igroup IG -initiator 50:06:0b:00:00:c2:8y:XX -force
Error: command failed: Initiator group does not contain the initiator

  •  Network->FC Ports were not detected and showing empty

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.