Skip to main content
NetApp Knowledge Base

Can an ATTO FibreBridge still be managed via the Web Interface if it is secured / securebridge has been done on the bridge?

  1. Last updated
  2. Save as PDF
Views:
632
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
metrocluster
Last Updated:

​ ​ ​  

Applies to

  • ATTO 7500N FibreBridge
  • ATTO 7600N FibreBridge

Answer

After an ATTO FibreBridge has been secured using the securebridge command all ethernet functionality of the bridge is disabled and the management ports are disabled.

All configurations, data collections, monitoring and firmware updates can be done from ONTAP 9.5 and later.

Additional Information

How to update the ATTO FibreBridge firmware on a secured FibreBridge

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device