Skip to main content
NetApp Knowledge Base

Is there a way to forcibly stop a SnapMirror process during XDP transfer when the `snapmirror abort` command fails?

  1. Last updated
  2. Save as PDF
Views:
10
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror

Answer

  • The `snapmirror abort` command is typically utilized to pause a SnapMirror transfer.
  • Nonetheless, should this command be ineffective and the process remains uninterrupted, there exists no direct approach to forcibly halt the transfer.
  • In such cases, it is recommended to contact NetApp Technical Support for assistance.

Additional Information

additionalInformation_text
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.