Skip to main content
NetApp Knowledge Base

After cluster setup can not see FCP adapter ports

  1. Last updated
  2. Save as PDF
Views:
85
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
SAN
Last Updated:

Applies to

  • ONTAP

Issue

  • All FCP ports on FC adapter card are not working but connection is good with switches and FCP adapter show online up other node is working as expected
  • Hardware Universe confirms card support for block storage FCP
 
Example:
Cluster1::> network fcp adapter show
Node         Adapter  Established Address Status   Status
------------ -------- ----------- ------- --------
Node-01       5a       true        3d0200  up       online

Cluster1::> system node hardware unified-connect show
Current  Current    Pending  Pending    Admin
Node          Adapter  Mode     Type       Mode     Type       Status
------------  -------  -------  ---------  -------  ---------  -----------
Node-01       5a       fc       initiator  -        -          online

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.