Skip to main content
NetApp Knowledge Base

How to enable periodic Cisco switch data collection for NetApp cluster switches with ONTAP 9.7 and earlier

  1. Last updated
  2. Save as PDF
Views:
34
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • Cisco Nexus switches
  • Cluster switch, Storage switch or MetroCluster IP switch
  • ONTAP 9.7P7 and later
  • ONTAP 9.6P8 and later
  • ONTAP 9.5P14 and later

Description

Enabling periodic data collection of Cisco Cluster, Storage or MetroCluster switches can significantly reduce time to solution of support cases and enables proactive notification based on switch data (delivered via Active IQ Digital Advisor Risks).

  • This article describes how to enable periodic data collection for Cisco switches in ONTAP 9
  • Once configured, data collection by ONTAP will occur on an hourly basis
  • The procedure is non-disruptive

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.