Skip to main content
NetApp Knowledge Base

What is E-Series SMI-S Array Management Utility error code 10?

Views:
222
Visibility:
Public
Votes:
0
Category:
e-series-santricity-smi-s-provider
Specialty:
esg
Last Updated:

 

Applies to

E-Series

Answer

When trying to add a storage system to the E-Series SMI-S Provider using the Array Management Utility software, the utility performs a communication check with the storage system prior to adding the system to the Provider. If the communication test does not pass, then a code 10 will be returned.

Check to make sure network traffic can pass to the storage systems from the SMI-S Provider server. Port 2463 needs to be open, as the Provider uses it to communicate to the storage systems.

Additional Information

Add your text here.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device