Skip to main content
NetApp Knowledge Base

Why did MetroCluster switch over when one node panicked

  1. Last updated
  2. Save as PDF
Views:
33
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9

Answer

One node had already panicked and been taken over so the HA pair was in takeover mode. When the second node panicked takeover was not possible so switchover was triggered.

Additional Information

additionalInformation_text
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.