Skip to main content
NetApp Knowledge Base

Switchback vetoed after FCVI replacement

  1. Last updated
    Jun 6, 2022
  2. Save as PDF
Views:
345
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
6/6/2022, 12:18:57 PM

 

Applies to

  • MetroCluster FC
  • virtual interface over Fibre Channel (FC-VI) card replacement

Issue

  • The FC-VI Card was replaced in one of the two node MetroCluster FC
  • Attempting to switch back fails with the error message:

Errors: Failed to validate the node and cluster components before the switchback operation.
node1 (non-overridable veto): Failed to read DR partner state. Verify that the Fibre Channel interconnect is up and retry the operation.

  • ClusterA-01 (Which took over ClusterA-02) does not have an address in the output of metrocluster interconnect adapter show

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.