Skip to main content
NetApp Knowledge Base

SCSI command TimeOuts, checkCondition errors during reboot of a back-end device

  1. Last updated
  2. Save as PDF
Views:
1,310
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Fabric MetroCluster

Issue

SCSI command TimeOuts and checkCondition errors from the Storage Enclosure Services (SES) devices reported during a reboot of an ATTO Bridge or a back-end switch on the same path.

With the reboot during a firmware upgrade of a Bridge we see the target and enclosure services devices report not ready:

Sat Jun 20 06:55:59 MSK [cluster_01-02: isp2400_asyncd_1: scsi.cmd.selectionTimeout:error]: Processor device FC_switch_A_2:7.126L0: Adapter/target error: HA status 0x7: cdb 0x3c. Targeted device did not respond to requested I/O. I/O will be retried. 
Sat Jun 20 06:56:46 MSK [cluster_01-02: isp2400_intrd: scsi.cmd.checkCondition:error]: Enclosure services device FC_Switch_A_1:7.126L1025: Check Condition: CDB 0x3b: Sense Data SCSI:not ready -  (0x2 - 0x35 0x2 0x0)(51). 

...

We see only 3 seconds later the Enclosure services device reports request successful after retry over the redundant path:

Sat Jun 20 06:56:49 MSK [cluster_01-02: isp2400_intrd: scsi.cmd.retrySuccess:debug]: Enclosure services device FC_switch_A_2:7.126L25: request successful after retry #2/#0: cdb 0x3b (2023).

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.