Skip to main content
NetApp Knowledge Base

Metrocluster configure failed "MetroCluster configuration has not been done"

  1. Last updated
  2. Save as PDF
Views:
45
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ONTAP 9

FC MCC

Issue

Attempting to create (configure) a Metrocluster during initial setup fails with:

"Error: command failed: MetroCluster configuration has not been done. Run "metrocluster show" to verify if MetroCluster is configured":
  
cluster::*> metrocluster configure -allow-with-one-aggregate true

Warning: Using this option will result in creation of both CRS metadata volumes on one aggregate.         
This can result in failure of configuration replication across the two DR sites if the lone aggregate fails.         
When a second data aggregate is created, one of the metadata volumes must be moved to the new aggregate for increased resiliency using the "volume move" 
command (privilege: advanced).

Do you want to continue? {y|n}: y

Error: command failed: MetroCluster configuration has not been done. Run "metrocluster show" to verify if MetroCluster is configured

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.