Skip to main content
NetApp Knowledge Base

MetroCluster "switchover -simulate" fails due to remote cluster not healthy

  1. Last updated
  2. Save as PDF
Views:
322
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster

Issue

metrocluster switchover -simulate operation fails with the following error:

Failed to set up the node and cluster components for the switchover operation.

NodeA (fatal): Not all nodes on the remote cluster are healthy. Verify that the nodes on the remote cluster are healthy using the "cluster show" command on the remote cluster, then try the command again.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.