Skip to main content
NetApp Knowledge Base

MetroCluster IP ports not coming up with compliant switches

  1. Last updated
  2. Save as PDF
Views:
9
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • MetroCluster IP

  • MetroCluster-compliant switches

  • T62100 MetroCluster Adapters 

Issue

  • In MetroCluster IP installation with compliant switches, MetroCluster ports are not coming up

  • metrocluster configuration-settings connection connect fails

  • Connected switch ports running on 40G speed, but 100G cables are connected

  • sysconfig -a shows the ports as down:

    slot 1: Dual 40/100G Ethernet T62100-CR
    e1a MAC Address: 00:01:02:03:05:06 (auto-unknown-fd-down)
    e1b MAC Address: 00:01:02:04:05:06 (auto-unknown-fd-down)
    Device Type: T6 2
    Firmware Version: 1.27.5.0
    Part Number: 110122860F0
    Hardware Revision: 0
    Serial Number: PT20240000

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.