Skip to main content
NetApp Knowledge Base

MetroCluster IP initialized with incorrect ADP configuration

  1. Last updated
  2. Save as PDF
Views:
131
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • New MetroCluster IP Installation
  • ONTAP 9
  • Advanced Disk Partitioning (ADP)

Issue

  • After configuring the MetroCluster, partition assignment does not work as expected
    • Disks are assigned using whole-shelf assignment policy when the config has less than 4 shelves
  • The root aggregate is smaller than the minimum size
    • The number of root partitions is too few
    • The size of the root partitions is too small

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.