Skip to main content
NetApp Knowledge Base

MetroCluster IP: Configure of remote node failed

  1. Last updated
  2. Save as PDF
Views:
33
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9
  • Repurposed nodes

Issue

Whilst trying to repurpose previously-used nodes into a MetroCluster IP, the following message is observed during the Implementing the MetroCluster configuration step
 
Example:

::> metrocluster configure -node-name ClusterB
[Job 148] Configuring Clusters
[Job 148] Job failed: Configure of remote node "ClusterA-01" in cluster "ClusterA" failed. Reason: (Found multiple DR sites). Check the hardware for errors and make sure all nodes are online, then try the command with "-refresh true". Use the "metrocluster operation show" command to view detailed error information. Resolve the errors, then try the command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.