Skip to main content
NetApp Knowledge Base

2 node MetroCluster negotiated switchover vetocheck_locked

  1. Last updated
  2. Save as PDF
Views:
137
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • 2 node MetroCluster FC
  • ONTAP 9

Issue

  • After a successful switchover and switchback metrocluster switchover -simulate true fails with message:
Job failed: Failed to validate the node and cluster components before the switchover operation. Use the "metrocluster
operation show" command to view detailed error information. Resolve the errors, then try the command again.
  • metrocluster operation show output shows:
CL01::CL01-N01 (non-overridable veto): Cannot perform this operation while this node is in switched over
state, verify the node is in normal mode by running "metrocluster node show" and retry the operation
again
  • metrocluster switchback -simulate true fails with message:

Info: Switchback not needed. There are no aggregates or disks belonging to the DR partner cluster on the local cluster.

  • metrocluster node show output shows:

DR                                         Configuration      DR
Group     Cluster
                        Node               State              Mirroring     Mode
----- ------- ------------------ -------------- --------- --------------------
1
          CL01
                        CL01-N01           configured         enabled       negotiated switchover vetocheck_locked
          CL02

                        CL02-N01           configured         enabled       negotiated switchover vetocheck_locked

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.