Skip to main content
NetApp Knowledge Base

Do we need to reset the switch to factory default before applying new switch software

  1. Last updated
  2. Save as PDF
Views:
385
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Broadcom IP switches
  • MetroCluster IP

Answer

Yes, Before installing a new switch software version and RCFs, you must erase the Broadcom switch settings and perform basic configuration.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.