Skip to main content
NetApp Knowledge Base

Configuration alerts on ConfigAdvisor but no alerts on ActiveIQ

  1. Last updated
  2. Save as PDF
Views:
71
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Fabric MetroCluster
  • Brocade FC Switches
  • ONTAP 9

Issue

Configuration alerts on ConfigAdvisor but no alerts on ActiveIQ

Example:
  • Verify that no TrafficIsolation (TI) zone exist on any of the back-end switches.
  • Firmware 9.2.0a is not supported for ONTAP 9.12.1. Please check the Interopability Matrix for your version of ONTAP - if the firmware is listed as supported this alert can be ignored.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.