Skip to main content
NetApp Knowledge Base

Configuration Reserved error reported in ATTO FibreBridge

  1. Last updated
    Nov 3, 2021
  2. Save as PDF
Views:
545
Visibility:
Public
Votes:
1
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:
11/3/2021, 9:13:25 AM

Applies to

  • MetroCluster
  • ATTO 7500N FibreBridge
  • ATTO 7600N FibreBridge
  • Bridge managed from ATTO CLI

Issue

When attempting to run commands on the CLI of an ATTO 7500 bridge the following error message is reported:

ERROR  Process 4096 has the configuration reserved.
        Id of this session = 8192

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.